Filter
Top Products
page 7
C O M M E R C I A L P R O D U C T S D I V I S I O N
3. Stand next to the treadmill and press QUICK START. The running belt
begins moving at 1 mph (1.6 kph) after a warning message scrolls across
the display.
4. Continue to stand next to the treadmill and increase the running belt speed
to 2 mph (3.2 kph) using the SPEED key.
CAUTION: If you hear any chafing or the belt begins to shred, stop the
running belt immediately by pressing the STOP key. Turn OFF the unit
and do not use the treadmill. Consult with your local dealer or Precor
representative.
5. Walk around to the rear of the treadmill and observe the belt as it runs over
the rear roller (watch for about one minute).
• If the running belt remains centered on the treadmill, then the belt is
functioning correctly and no adjustment is necessary.
• If the running belt drifts to one side, then you need to adjust the belt; see
Aligning the Running Belt in the maintenance section of this manual for
instructions.
Important: If you notice that the belt needs alignment, make the
adjustments at once before using the treadmill. Failure to do so might
cause the belt to tear or fray which is not covered by the limited warranty.
6. Press STOP/PAUSE to slow the running belt to a gradual stop.
If the belt is functioning correctly, the treadmill is assembled and ready to use.