Filter
Top Products
page 2
C O M M E R C I A L P R O D U C T S D I V I S I O N
You do not need any special knowledge or experience to set up a C964i or C962i
treadmill, however you will need assistance. Because of the size and weight of
the treadmill, it is recommended that at least three people assemble it.
INSTALLATION REQUIREMENTS
Follow the installation requirements below when installing and assembling the
treadmill. If you do not install the treadmill according to the following guidelines,
you could void the Precor limited warranty.
• Set up the treadmill on a solid, flat surface. A flat surface is required for
your safety and proper alignment of the running belt. An adjustable foot
exists to help “fine tune” the unit once it is in place.
• Locate the treadmill at least 4 feet from walls, equipment, and furniture.
Be sure to allow ample space in front of the machine to allow easy access
to the ON/OFF switch. Open space to the sides and rear of the unit makes
for a safer mount and dismount and easier belt adjustment.
• Fill out and mail the limited warranty card. The serial number is located
on the inboard-side of the running bed at the left, rear corner of the treadmill.
You will need to be on your knees and bend down to see it. Write the serial
number in the space provided on the inside front cover of this manual.
• Use the appropriate voltage, dedicated circuit, and grounding as
specified on the treadmill. The treadmill is available in both 120-volt and
240-volt models. Refer to the treadmill’s identification label to determine the
voltage that your treadmill requires. Both the 120-volt and 240-volt models
require a dedicated 20 amp circuit.
• Acquire the appropriate tools. You will need assistance and a wire cutter.
A bubble level is also useful to check the running surface of the treadmill
once it is assembled and placed in its final location.
CAUTION: Do not use a non-grounded outlet or transformer. Do not
remove or otherwise bypass the plug with an adapter. Electrical damage
can occur and void the Precor limited warranty if the treadmill is connected
to an improper power source.
Setting Up the C964 Treadmill Ergometer
Setting Up the Treadmill