Filter
Top Products
page 31
COMMERCIAL PRODUCTS DIVISION
The following occurs:
The age (1 through 99) that appears on the display becomes
the designated age that the C934 uses for SmartRate
®
. A cor-
rect age entry between 1 and 99 is very important if the user
plans to utilize the heart rate characteristics of the treadmill.
The QUICKSTART key acts the same as the ENTER key at
this point because all the Setup prompts have been answered.
Press QUICKSTART at
the,...
AGE prompt
DISPLAY FEATURES DURING A WORKOUT
Note: The Setup prompts that appear in this display prior to a workout need to be
addressed using the keypad keys. Refer to
Setup Mode and Prompts
on page 29.
During workouts, the course profile that appears in the display corresponds
to the selected course. The blinking column in the course profile indicates the
incline level and user’s progress along the course.
Once the running belt begins moving, indicator lights appear in the columns below
the display and indicate which information is being displayed. A user can highlight
a particular feature by pressing the appropriate SELECT key.
The following describes the information that can appear in the display.
TIME: As a user works out, TIME indicates the amount of time spent in his or her
work out. The time (00:00) display appears when the workout begins. Time ap-
pears in minutes and seconds. However, should a user exceed 60 minutes (during
a single workout), the Time display converts to hours and minutes. When
QUICKSTART is pressed at the banner or INFINITE is available and is selected
during the Setup prompts, the Time display shows how long a user has been
working out. However, in warm-up and cool-down periods, and in all other courses,
the Time display indicates the minutes remaining.
Important: A user’s “pace” (time per mile or kilometer) can also be displayed in
the TIME field. Refer to the SPEED keys on page 34.
DISTANCE: The distance travelled appears (0.00) once a user begins a course.
The distance can appear in miles or kilometers. Note that if the distance exceeds
65 miles (km) in a single workout, the display resets to zero. To change which
units of measure appear on the display, the club owner or manager can follow
the instructions found in
Club Information
on page 23.