Precor C934 Treadmill User Manual


 
page 30
COMMERCIAL PRODUCTS DIVISION
TIME: Acceptable entries range between INFINITE and 240 minutes. (See “Note”
below.) The display blinks to indicate that it is awaiting a selection. Use the and
keys to change the selection. To continue in Setup mode, press ENTER.
Note: The Club manager has the ability to set a time limit on the length of a
workout. Refer to
Club Information
on page 23. (The Weight Loss and Cross
Country courses have a preset time limit so a WORKOUT TIME prompt does not
occur when a user chooses WTLS or XCTR.)
WEIGHT: Acceptable entries range from 1 through 999 (pounds or kilograms). A
user can change the blinking number using the and keys or accept the
displayed number (and continue in Setup mode) by pressing ENTER.
Important: A number that reflects the user’s actual weight must be entered since
the calorie count and several other calculations are based on the weight entry.
AGE: Acceptable entries range from 1 to 99. Change the blinking number using
the and keys or accept the displayed number by pressing ENTER. Initially,
the number zero appears on the display. Once the key is pressed the number
jumps to 35.
Important: An age entry is required if a user wants to use the heart rate interac-
tive capabilities of the treadmill. Refer to QUICKSTART on page 34.
THE SETUP MODE AND THE QUICKSTART FEATURE
The QuickStart feature can be pressed any time during the Setup prompts. See
the table below.
Note: Default values apply if QUICKSTART is pressed while the Precor banner
is displayed. Refer to
QUICKSTART
on page 34.
The following occurs:
Bypass the remaining Setup prompts and the running belt
begins moving after a three second countdown. The Manual
course appears and default values apply.
The profile associated with the course appears on the right
side of the display.
The information that appears on the display becomes the work-
out time for the course. A user can change the display using
the or keys. Refer to
Club Information
on page 23.
The weight (1 through 999) that appears on the display
becomes the user’s designated weight that the C934 uses to
compute various calculations.
Precor banner
COURSE prompt
TIME prompt
WEIGHT prompt
Press QUICKSTART at
the,...