Filter
Top Products
page 28
COMMERCIAL PRODUCTS DIVISION
ENTER: Workout specific prompts need to be answered and “entered” into memory.
Pressing ENTER selects the information being displayed and processes it.
QUICKSTART: During Setup mode, QuickStart lets the user bypass further prompts
and start a workout immediately using the Manual course.
Default values apply.
Note: During a course change, pressing QUICKSTART starts the new course.
Refer to
Selecting a New Course During a Workout
on page 34.
QUICKSTART Default Values
Prompts Default Value
1 Manual Course Manual
Enter Time Club limit. Note that the Weight Loss course is fixed at 28
minutes.
Enter Weight 150 lbs. (68 kg.)
Enter Age 0 : A valid Age must be entered to utilize the SmartRate
®
display. If QUICKSTART is pressed
after
the Age prompt
appears, then the SmartRate
®
display will appear when the
user grasps the touch-sensitive grips on the handlebar or
wears the POLAR
®
chest strap. If no Age entry occurs, the
SmartRate
®
display lights up, but no blinking sensor appears.
The QUICKSTART key can be pressed any time during the Setup prompts. De-
fault values apply after that point. See the table below.
Press QUICKSTART at the... The following occurs:
Precor banner The user bypasses the Setup prompts and begins
working out in the Manual course.
Course prompt The displayed course is accessed.
Time prompt The time that appears on the display becomes the
workout time limit. TIME may be set to any value
from 1 to the Club limit. If “unlimited” workout time
is allowed by the Club, a user can select it by
entering 0 with the numeric key.
Weight prompt The weight that appears on the display becomes
the designated weight that the C846 uses to
compute statistics. Acceptable entries are
between 1 and 999.
Age prompt The age that appears on the display becomes the
designated age that the C846 uses to compute sta-
tistics. A correct age entry between 1 and 99 is very
important if the user’s plan to utilize the heart rate
features of the C846. The QUICKSTART key acts
the same as the ENTER key at this point because
the user has answered all the Setup prompts.