Filter
Top Products
Connect the power cord.
CAUTION: Use the supplied power cord. Do not remove or
otherwise bypass the 3-prong plug with an adapter in order
to use a non-grounded outlet. Do not plug the EFX into a
power transformer in an attempt to adjust the voltage
requirements. Failure to follow these instructions might
damage the unit and void the Precor Limited Warranty.
1. Insert the power plug connector into its
receptacle at the rear of the unit.
2. Plug the other end into a grounded
outlet. Be sure to use the appropriate
voltage. Refer to Grounding
Instructions in the owner’s manual.
Turn the unit ON.
Use the ON/OFF (I/O) power switch to turn the unit ON. Check that
the Precor banner appears on the display. If the display remains
blank, recycle the power, and then check the cable connections.
Level the EFX.
Before exercising, make sure the EFX does not wobble from side to
side or front to back. Ask a capable person for help to make
adjustments.
Important: If the unit is placed on a slightly uneven surface,
adjusting the rear pads can help, but will not compensate for
extremely uneven surfaces.
1. To remove any side-to-side
movement, rotate the rear pads.
2. To counteract any front-to-back
rocking motion, ask your assistant to
grasp the upper handrails and raise
the front of the unit off the floor. Use
a crescent or combination wrench to
loosen the nut on the height adjuster.
3. Turn the height adjuster to eliminate
the rocking motion.
Once you have the proper height
adjustment, use the wrench to turn
the nut and tighten it securely against
the base tube.
Important: If, sfter performing the
steps above, the unit still rocks
slightly from front to back, you may
need to remove the nut on the height
adjuster.
4. Have your assistant carefully lower the unit to the floor.
www.precor.com
EFX5.33 AG 48170-403, en
03 October 2005
Precor Incorporated
20031 142nd Avenue NE
P.O. Box 7202
Woodinville, WA USA 98072-4002
©2005 Precor Incorporated