Filter
Top Products
Owner’s Manual: Programs 40
During the course, the TIME display relates to the amount of
time remaining in the recorded columns. Total elapsed time
appears when you record new columns.
Note: The length of the custom program and number of
resistance and incline settings are limited to the available
memory in the EFX. The program will not end if the available
memory is exhausted, but the display notifies you and
further changes to resistance or incline are not saved.
Approximately six hours of recording time is available for
the two user IDs.
Clearing the Settings on a Custom Program
Perform the following steps to clear (delete) any resistance
or incline settings stored in a custom program.
1. At the Precor banner, press USER 1 or USER 2, and then
press ENTER.
2. Use any arrow key to specify the custom program (CST1
or CST2) that you wish to clear.
Important: Clearing the resistance and incline settings
from a custom program permanently deletes them from
memory.
3. Press and hold the SELECT key associated with the user
ID specified earlier for ten seconds. A prompt appears on
the display indicating that you are holding the key to clear
a custom program. After the message CLEARED appears
on the display, you can release the key.
Note: During the 10-second delay, you can release the
SELECT key and no change will occur to the custom
program settings.
EFX_Owners Manual.book Page 40 Friday, June 16, 2006 9:25 AM