Filter
Top Products
FIGURE 4
i
]
;TEP 4:
¯
Attach eight PARAGLIDE STRIPS (31) to both UPRIGHT TUBES on the UPRIGHT FRAME (1) (FGUR ON EACH END)
shown in FIGURE 4 using the following steps:
¯
Thoroughly clean all surfaces where the PARAGLIDE STRIPS are to be attached.
¯
Remove the PARAGLIDE STRIPS from the paper backing and firmly apply them to all shown surfaces.
¯ Attach eight PAlL&GLIDE STRIPS (31) to each SADDLE (6) (FOUR ON EACH END) as shown in FIGURE
¯
Slide two 1-1/4 X 5" GRIPS (30) over the DIP HANDLES of both SADDLES (6). (IF A LUBRICANT IS REQUIRED,
THE INSIDE OF THE GRIP WITH RUBBING ALCOHOL.)
¯
Pull back the SPRING PIN on the UPRIGHT TUBES, and insert the SADDLES (6) as sho~vn in FIGURE 4.. Slide the SADDLE
(6) do~vrt to the desired height and release the SPRING PIN into the hole.
¯ Secure the SADDLES (6) in place with two THUMBSCREWS (29) as shown in FIGURE 4. When ready to perform the
EXERCISE, simply insert the SADDLES (6) into the UPRIGHT TUBES and tighten the two THUMBSCREWS
7