Filter
Top Products
FIGURE 1
STEP 1:
¯
Attach eight PARAGLIDE STRIPS (31) to the WOLFF SLEEVE (4) (FOUR ON EACH END) as shown in FIGURE 1 using
following steps:
¯ Thoroughly clean all surfaces where the PARAGLIDE STRIPS are to be attached.
¯ Remove the PARAGLIDE STRIPS from the paper backing and fLrmly apply them to all shown surfaces.
¯
Insert one U-PIN (10) through the BUSHING of the WOLFF SLEEVE (4) and attach one PAL NUT (28) to the end of the
(10) as shown in FIGURE
¯
SECURELY assemble one 3/8" SPRING PIN ASSEMBLY (25) to the SPRING PIN HOUSING on file WOLFF SLEEVE (4)
shown in FIGURE 1. (!!! IMPORTANT !!! TIGHTEN THE NUT OF THE SPRING PIN ASSE~cIBLY SECURELY)
1/2 I 1/2 I 1/2 I 1/2 I 1/2 I 1/2
6