Filter
Top Products
FIGURE 2
STEP 2:
¯
Pull back the SPRING PIN on the WOLFF SLEEVE (4) and slide it over the end of the BENCH Ft?~AelE (2) as shown
FIGURE 2. Engage the SPRING PIN into one of the adjustment holes.
¯ Insert two 2" SQ. END CAPS (33) into both ends of the BASE LEG (5) as shown in FIGURE
¯
Insert one U-PIN (10) through the BUSHING on the bottom of BENCH FRAME (2) and attach one PAL NUT (28) to the
the U-PIN (10) as shown in FIGURE
¯
Insert the BASE LEG (5) into the front of the BENCH FRAME (2) as shown in FIGURE 2. (MAN~E SURE THAT THE
ON THE BASE LEG IS UNDER THE BENCH FRAME)