Filter
Top Products
LOV~
FIGURE 8
STEP 8:
¯ Insert three 1-3/4" SQ. END CAPS (23) into the ends of the LEG EXTENSION. (8) as shown in FIGURE
¯ Insert two 1/2" FLANGE BEARINGS (26) into the BUSHING on the LEG EXTENSION (8) as shown in FIGURE
¯ Assemble the LEG EXTENSION (8) to the LEG EXTENSION NECK (7) as shown in FIGURE 8, using one 1/2 X 3"
(18), two 1/2" WASHERS (22), and one 1/2" LOW HEIGHT LOCK NUT (24). (TIGIITEN TIlE CONNECTION
TO REMOVE TIlE PLAY, YET ALLOWING TIlE LEG EXTENSION TO ROTATE FREELY)
¯
Assemble four ROLLER PADS (12) to the LEG EXTENSION (8) as shown in FIGURE 8, using two ROLLER PAD SHAFTS
(11), and four 3/4" STARLOCK COLLARS (27).
¯ Attach one 3/4" SQ. RUBBER BUMPER (32) to the LEG EXTENSION (8) approximately where shown in FIGURE
11