Filter
Top Products
704101 REGGIE WHITE ALL PRO SYSTEM ASSEMBLY INSTRUCTIONS
THANK YOU
FOR PURCHASING THE 7114101 REGGIE WHITEALL PRO SYSTEM~ PLEASE SAVE THESE
ASSEMBLY INSTRUCTIONS FOR YOUR PERSONAL REFERENCE, AND ADDITIONAL SERVICE
INFORMATION.
***IMPORTANT***.
THE 7~0410I REGGIE WHITEALL PROSYSTEM MUST BE ASSEMBLED ON A FLAT, LEVEL
SUR(ACE TO ASSURE ITS PROPER FUNCTION.
PARABODY STRONGLY RECOMMENDSTHAT THIS PRODUCT BE ASSEMBLED BY TWO
PEOPLE TO AVOID POSSIBLE INJURY.
KEEP ALL FRAY. CONNECTIONS LOOSE, UNTtL IYSTRUCTED ~ THE ASSEMBLY STEP
SEQUENCES TO SECURELY TIGWrEN.
IF" YOU EXPERIENCE ANY PROBLEM WITH THE ASSEMBLY OF THIS PRODUC’F, PLEASE
CONTACT YOUR DEALER OR YOUR PARABODY CUSTOMER SERVICE REPRESENTATIVE
AT: 1-800-328-9714
TOOLS REQUIRED: RATCHET, 9/16 SOCKET or WRENCH, ADJUSTABLE WRE~CH, and
~UBBER MALLET or HAMMER
Slide two (2) 2 IN. SQ. COVER CAPS over the ends of.:he BASE as shown on drawing.
lnse~’t one (I) 1-.3/4 IN. SQ. END CAP into the end of the BASE of the UPRIGHT FRAMI:’, as shoxvn
drawing.
SECURELY assemble the UPRIGHT FRAME to the BASE as shown on drawing, using two (2) 3/8 X
IN. BOLTS, four (4) 3/8 IN. WASHERS, and t~vo (2) 3/$ IN. LOCK NUTS. (BEFORE TIGHTENING
CONNECTION MAKE SURE THAT THE UPRIGHT FRAME IS SQUARE TO THE BASE)
Attach eight (8) PAKAGLIDE STRIPS to the CARRIAGE as shown in (DETAIL A) using the following
steps:
A.
Thoroughly clean all inside surfaces where the pAtLA.GLIDES are to be attached.
B.
Remove the PARAGLIDES from paper backing the and firmly apply them to all shown surfaces
(8 places)
Attach one (I) 3/4 IN. SQ. RUBBER BUMPER to the CENTER of the CARRIAGE STOP on the
CARRIAGE.
Slide the CARRIAGE down over the REAR UPRIGHT of the UPRIGHT FRAME as; shown on
drawing
4
I/21/95