Filter
Top Products
1
FIGURE 1
STEP 1
• If upon completion of assembly, the HEAD PLATE (20) does not sit on top of the first WEIGHT PLATE (58), push the HEAD PLATE
(20) down, insert the WEIGHT STACK PIN (34) and perform several repetitions at the press station. This will relax the cable system and
prevent the HEAD PLATE (20) from lifting up. See FIGURE 1.
• If after completing previous step, the HEAD PLATE (20) still does not sit on top of the first WEIGHT PLATE (58) or if there is
excess slack in the cable system, adjust the threaded end of the WEIGHT STACK CABLE (26) and the ADJUSTABLE GLIDE (37)
accordingly and retighten the jam nut. See FIGURE 1.
26
58
20
37
250101 ADDENDUM INSTRUCTIONS
!! IMPORTANT !!
PLEASE USE THE ATTACHED INSTRUCTIONS TO ADJUST
THE CABLE TENSION.
• For maximum performance, the HEAD PLATE (20) should should just barely sit on the top WEIGHT PLATE (58) and the FLOATING
PULLEY BRACKET (6) should firmly contact the PLATE on the FRONT UPRIGHT (2). See FIGURE 1.
34
2
PLATE
1Part # 6796601 Revision: 09/9/98
6