Filter
Top Products
Analyzing. The ECG data is being analyzed.
No action required. Wait until
analysis ends.
MESSAGES
50
MESSAGE CAUSE CORRECTION
Cannot measure.
Please follow the instructions for
use.
An ECG wave-pattern could not
be detected.
Check the instructions and repeat
measurement.
Measurement was stopped.
Push START to begin
measurement again.
The measurement was
interrupted or cancelled.
Press START to resume the
measurement.
Copied
*1
data into SD.
The indicated ECG data has been
copied to an SD memory card.
No action required.
Wait until the message disappears.
Erased
*2
data.
The indicated ECG data has been
erased.
*1: Number of readings from 0 to 5. The number displayed represents the amount of copied ECG data.
*2: Number of readings from 1 to 300. The number displayed represents the amount of erased ECG data.
Warning Messages
Formatting SD memory.
DO NOT REMOVE SD
The SD memory card is being
formatted.
Wait until the message disappears.
Do not remove the SD memory card
until formatting has been completed.
MESSAGE CAUSE CORRECTION
LISTS AND EXPLANATIONS OF MESSAGES
Notice Messages