Filter
Top Products
8
8. Attach the Right and Left Press Arms (46, 82) to the
Main Upright (3) with the Pivot Rod (27), two Large
Washers (53), six 1 1/18Ó x 1/2Ó Flange Bushings
(18), and two 3/8Ó Nylon Jamnuts (63).
Make sure that the Arms (46, 82) are attached
exactly as shown.
86
50
46
33
82
85
50
45
12
20
45
7. Note: Some of the parts used in arm assembly are
located in the parts bag labeled ÒSeat Assembly.Ó
With the help of a second person, join the Right and
Left Press Arms (46, 82) with the Connector Tube
(12). Secure the Arms with two 3/8Ó x 3Ó Bolts (45)
and two 3/8Ó Nylon Locknuts (50).
Press a 2Ó Square Inner Cap (33) into the ends of the
Right and Left Press Arms (46, 82). Press a ?Ó Round
Inner Cap (20) and a ?Ó Round Inner Cap (85) into
each end of the Right and Left Press Arms (46, 82).
Slide a Long Grip (86) onto the indicated ends of the
Right and Left Press Arms (46, 82).
8
53
18
46
63
27
63
18
3
18
82
53
9. Open the parts bag labeled ÒCABLE ASSEMBLY.Ó
Refer to the Cable Diagram on page 16 as you
assemble the Cables.
Identify the High Cable (73). It is approximately 188Ó
long (the shortest Cable), and it has a ball on one
end and a bolt on the other.
Locate the end of the High Cable (73) with the bolt.
Feed this end through the indicated slot in the Main
Upright (3) from below. Feed almost all of the Cable
through the slot.
Slide a 3/8Ó Flat Washer (55) and a 5/8Ó x 1/2Ó Pulley
Bushing (42) onto a 3/8Ó x 2 1/2Ó Bolt (54).
Wrap the High Cable (73) around a 4Ó Pulley (35) and
slide both the Pulley and Cable into the slot in the
Main Upright (3). While holding the Pulley with one
hand, insert the 3/8Ó x 2 1/2Ó Bolt (54) through the
hole in the Main Upright, through the Pulley and
through the other side of the Upright.
Slide a 5/8Ó x 1/2Ó Pulley Bushing (42) and a 3/8Ó Flat
Washer (55) onto the 3/8Ó x 2 1/2Ó Bolt (54). Then
tighten a 3/8Ó Nylon Jamnut (63) onto the Bolt.
9
Cable Assembly
Ball
Bolt
Slot
35
73
55
54
42
55
3
42
63
Arm Assembly
7