Filter
Top Products
10
15. Dis-assemble the pre-assembled Pulley Plates (31).
Note that on one end, the Pulley Plates have several
adjustment holes. These holes must be closest to the
floor.
Wrap the High Cable (73) around a 4Ó Pulley (35).
Attach the Pulley to the upper end of the Pulley
Plates (31) with a 3/8Ó x 1 3/4Ó Bolt (60), a Cable Trap
(44), and a 3/8Ó Nylon Jamnut (63). Make sure the
Cable is in the groove of the Pulley and that the
Cable Trap is oriented as shown, so it will hold
the Cable in place.
Put the remaining Pulley, Cable Trap, Jamnut and
Bolt aside. They will be used in step 19.
15
73
60
31
44
35
31
63
Adjustment
Holes
14. Feed the bolt on the High Cable (73) back through
the slot in the Main Upright (3) in the direction shown.
Wrap the High Cable (73) around a 4Ó Pulley (35).
Attach the Pulley to the Main Upright (3) with a 3/8Ó x
2 1/2Ó Bolt (54), two 3/8Ó Flat Washers (55), two 5/8Ó x
1/2Ó Pulley Bushings (42), and a 3/8Ó Nylon Jamnut
(63).
14
55
42
63
3
35
42
55
54
73
13. Feed the bolt on the High Cable (73) through the indi-
cated slot in the Main Upright (3) in the direction
shown. The Cable should wrap around the Pulley that
was attached in step 11.
Wrap the High Cable around a 4Ó Pulley (35). The
Cable must wrap around the Pulley in the direction
shown.
Attach the 4Ó Pulley (35) to the Right and Left Press
Arms (46, 82) with the 3/8Ó x 8 1/2Ó Bolt (59) and the
3/8Ó Nylon Locknut (50).
13
50
73
59
3
82
46
35
Slot
Bolt