Filter
Top Products
12
20. Slide a Cable Trap (44) onto a 3/8Ó x 4Ó Bolt (65).
Wrap the Low Cable (72) around a 4Ó Pulley (35).
Attach the Pulley to the indicated hole in the Main
Upright (3) with the 3/8Ó x 4Ó Bolt (65), the Cable Trap
(44), a 5/8Ó x 1/2Ó Pulley Bushing (42), a 3/8Ó Flat
Washer (55), and a 3/8Ó Nylon Jamnut (63). Make
sure the Cable Trap is oriented as shown, so it
will hold the Cable in place.
20
42
35
63
65
44
3
72
55
18. Route the Low Cable (72) through the indicated slot
in the Main Upright (3) and the Base (8).
Wrap the Low Cable (72) around a 4Ó Pulley (35) in
the direction shown.
Attach the 4Ó Pulley (35) to the welded bracket on the
Main Upright (3) with a 3/8Ó x 2Ó Bolt (62) and a 3/8Ó
Nylon Locknut (50).
50
3
72
8
35
62
Slot
19. Wrap the Low Cable (72) around a 4Ó Pulley (35).
Slide the 4Ó Pulley (35) and a Cable Trap (44) in
between the two Pulley Plates (31).
Attach the 4Ó Pulley (35) and the Cable Trap (44) to
the lowest adjustment hole in the Pulley Plates (31)
with a 3/8Ó x 1 3/4Ó Bolt (60) and a 3/8Ó Nylon Jamnut
(63). Make sure the Cable is in the groove of the
Pulley and that the Cable Trap is oriented as
shown, so it will hold the Cable in place.
31
60
35
44
72
18
19
Adjustment
Holes
63