Filter
Top Products
19
Tightening the Cables
Woven cable, the type of cable used on the training sys-
tem, can stretch slightly when it is first used. If there is
slack in the Cables before resistance is felt, the Cables
should be tightened.
To tighten the Cables, insert the Weight Pin (39, not
shown) between the third and the fourth Weight, counting
from the top. See ÒChanging the Weight SettingÓ on page
17 for instructions on moving the Weight Pin.
Loosen the 1/2Ó Plain Nut (68) securing the bolt at the
end of the High Cable (73). Tighten the bolt a couple of
turns into the Weight Tube (36) until the Cables feel
tighter. Tighten the Plain Nut to prevent the bolt from turn-
ing.
Note: This drawing shows the Shroud removed for clarity.
The Shroud does not have to be removed to tighten the
Cables.
36
68
Bolt
73
39
Additional slack can be removed by moving the lower of
the two 4Ó Pulleys (35) attached to the Pulley Plates (31)
to one of the other adjustment holes in the Pulley Plates.
To do this, remove the 3/8Ó x 1 3/4Ó Bolt (60), Cable Trap
(44) and 3/8Ó Nylon Jamnut (63). Move the Pulley and re-
attach it with the Bolt, Cable Trap and Locknut. Make
sure the Low Cable (72) is in the groove of the Pulley
and that the Cable Trap is positioned as shown.
Note: If a Cable tends to slip off the Pulleys often, the
Cable may have become twisted. Remove the Cable
and re-install it.
If the Cables need to be replaced, see ORDERING
REPLACEMENT PARTS on the back cover of this manual.
35
63
72
31
Trouble-shooting and Maintenance
Inspect and tighten all parts each time you use the training system. Replace any worn parts immediately.
The training system can be cleaned using a damp cloth and mild non-abrasive detergent. Do not use sol-
vents.
44
60