Filter
Top Products
18
51. Attach the Backrest (60) to the Center Upright (3)
with two M6 x 70mm Screws (69) and two M6
W
ashers (66).
53. Locate the Weight Rest (15) with the Right
W
eight Rest Hook (17) attached to it. Set the
hooks on the Weight Rest over a set of knobs on
the Right Upright (5).
Repeat this step with the other Weight Rest
(not shown). Always set both Weight Rests
(15) at the same height.
52. Identify the Right Butterfly Pad (58) (see the inset
drawing). Attach the Pad to the Right Butterfly
Arm (8) with two M6 x 63mm Button Bolts (68)
and two M6 Washers (66).
Attach the Left Butterfly Pad (59) to the Left
Butterfly Arm (9) in the same manner.
51
60
66
69
52
53
68
66
8
58
9
58
15
17
5
59
54. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in
ADJUSTMENTS, beginning on the following page.
Before using the weight rack, pull each cable a few times to make sure that the cables move smoothly over
the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If the
cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE
DIAGRAMS on pages 21 and 22 of this manual for proper cable routing. If there is any slack in the
cables, you will need to remove the slack by tightening the cables. See TROUBLESHOOTING AND
MAINTENANCE on page 23.