Filter
Top Products
10
14. Wrap the Carriage Cable (56) over a 3 1/2” Pulley
(45). Attach the Pulley to the Center Top Frame
(2) with an M10 x 192mm Button Bolt (64) and an
M10 Nylon Locknut (62).
16. Locate the Butterfly Cable (53). Attach the
Cable to the Left Butterfly Arm (9) with an M8 x
45mm Shoulder Bolt (81), an M8 Washer (94),
and an M8 Nylon Locknut (82).
17. Wrap the Butterfly Cable (53) over a “V”-pulley
(46). Attach the “V”-pulley and a Long Cable Trap
(88) to the Center Upright (3) with an M10 x
58mm Button Bolt (75). Make sure the Cable
T
rap is oriented to hold the Cable in the
groove of the Pulley.
18.
Wrap the Butterfly Cable (53) under a 3 1/2”
Pulley (45).
Attach the Pulley to the Double “U”-
bracket (21) with an M10 x 48mm Button Bolt
(74) and an M10 Nylon Locknut (62).
15. Attach the end of the Carriage Cable (56) to a
“U”-bracket (19) with an M6 Nylon Locknut (63).
Do not completely tighten the Locknut; it
should be tightened so that only two threads
of the Cable show past the Locknut, as shown
in the inset drawing.
14
45
62
2
56
64
15
63
63
19
56
56
16
53
81
82
94
9
17
3
53
46
88
75
18
45
62
21
74
53
19