Filter
Top Products
12
24. Route the Base Cable (57) under the Rear
Upright (4) and a 3 1/2” Pulley (45). Attach the
Pulley to the Base (1) with an M10 x 192mm
Button Bolt (64) and an M10 Nylon Locknut (62).
26. Wrap the Base Cable (57) under a 3 1/2” Pulley
(45). Attach the Pulley to the Base (1) with an
M10 x 178mm Button Bolt (78) and an M10
Washer (65). Note: A nylon locknut will be
attached to the Bolt in step 45.
27. Wrap the Base Cable (57) under a 3 1/2” Pulley
(45).
Attach the Pulley to the Base (1) with an
M10 x 192mm Button Bolt (64) and an M10 Nylon
Locknut (62).
28. Attach the end of the Base Cable (57) to a “U”-
bracket (19) with an M6 Nylon Locknut (63). Do
not completely tighten the Locknut; it should
be tightened so that only two threads of the
Cable show past the Locknut, as shown in the
inset drawing.
25. Wrap the Base Cable (57) over a 3 1/2” Pulley
(45). Attach the Pulley and a Short Cable Trap
(47) at the second set of holes from the bottom of
the two Pulley Plates (20) with an M10 x 54mm
Button Bolt (73) and an M10 Nylon Locknut (62).
Make sure the Cable T
rap is oriented to hold
the Cable in the groove of the Pulley.
24
45
57
62
4
64
25
62
73
45
47
57
26
27
28
45
45
57
65
62
63
63
19
19
57
57
78
64
1
57
1
20
1