Filter
Top Products
9
10.Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some extra hardware
may be left over.Cover the floor beneath the elliptical exerciser to protect the floor from damage.
8.
Apply a thin film of the included high-temperature lubri-
cant to both Pivot Shafts (15).
Identify the Right Handlebar (9), which is marked with
a sticker. Apply a small amount of grease to the axle
on the Right Handlebar, to the Pivot Arm Cover (64),
and to the Inner Upright Cover (63).
Next, slide the
Right Handlebar onto the right Pivot Shaft (15), and
insert the axle on the Right Handlebar into the Right
Upright (3). Note: Position the Right Pedal (13) near
the top of the Incline Ramp (5), and then lift and
push the Pedal toward the center of the Incline
Ramp while inserting the axle into the Upright.
Place a Wave Washer (100) on the end of the axle on
the Right Handlebar (9). Next, apply a small amount of
grease to an M8 x 28mm Washer (99), and slide the
Washer onto an M8 x 25mm Button Screw (81).
Tighten the Button Screw into the axle.
Attach an Outer Upright Cover (74) to the Right
Upright (3) with two M4 x 25mm Screws (105).
Attach the Left Handlebar (10) to the left Pivot Shaft
(15) and the Left Upright (4) in the same way.
9
15
Lubricate
3
13
74
100
99
9. Plug the Power Cord (8) into the Power Receptical
(68) at the rear of the elliptical exerciser.
Next, plug the Power Cord (8) into an appropriate
outlet as described on page 10, and calibrate the
elliptical exerciser’s incline system by following
the steps on page 22.
8
68
9
8
63
64
81
105
10
5
4
Grease
15
Lubricate
Axle