Filter
Top Products
14
HOW T
O USE A PRESET PROGRAM
Press any button on the console or begin
pedaling to turn on the console.
See step 1 on page 12.
Select one of the fifteen preset programs.
To select one of the
fifteen preset pro-
grams, press the
Programs button
repeatedly until the
words “Weight Loss,”
“Aerobic,” or
“Performance” and the number 1, 2, 3, 4, or 5
appear in the center of the display.
When a preset program is selected, a profile of
the resistance settings of the program will scroll
across the matrix. The center display will show
how long the program will last.
Press the Start button or begin pedaling to
start the program.
Each program is divided into several one-minute
segments. One resistance setting and one pace
setting are programmed for each segment. Note:
The same resistance setting and/or pace setting
may be programmed for two or more consecutive
segments.
The resistance set-
ting for the first
segment will be
shown in the flash-
ing Current
Segment column
of the matrix. (The
pace settings are not shown in the matrix.)
The
resistance settings for the next several segments
will be shown in the columns to the right.
As you exercise, the Target Pace guide will help
you to keep your pedaling pace near the pace
setting for the current segment. When the words
“Too Slow” appear in the display, increase your
pace. When the words “Too Fast” appear,
decrease your pace. When the words “On Pace”
appear
, your pace matches the pace setting for
the current segment.
Important: The pace settings are intended
only to provide motivation. Your actual pace
may be slower than the pace settings. Make
sure to exercise at a pace that is comfortable
for you.
When only three seconds remain in the first seg-
ment of the program, both the Current Segment
column and the column to the right will flash, a
series of tones will sound, and all resistance set-
tings will move one column to the left. The resis-
tance setting for the second segment will then be
shown in the flashing Current Segment column,
and the resistance of the elliptical exerciser will
change to the resistance setting for the second
segment. Note: If all of the indicators in the
Current Segment column are lit after the resis-
tance settings have moved to the left, the resis-
tance settings may move downward so only the
highest indicators appear in the matrix.
The program will continue until the resistance
setting for the last segment is shown in the
Current Segment column and the last segment
ends.
Note: During the program, you can override the
resistance setting for the current segment, if
desired, by pressing the 1 Step Resistance but
-
tons. However
,
when the next segment begins,
the resistance will change if a different resistance
setting is programmed for the next segment.
If you stop pedaling for several seconds, a tone
will sound and the program will pause. To restart
the program, simply resume pedaling.
3
2
1
Current Segment