Filter
Top Products
7
Assembly requires two persons. Set the INCLINE TRAINER in a cleared area and remove all packing materials.
Do not dispose of the packing materials until assembly is completed. Assembly can be completed using the
included allen wrenches.
Note: The underside of the INCLINE TRAINER walking belt is coated with high-performance lubricant. During
shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This
is a normal condition and does not affect INCLINE TRAINER performance. If there is lubricant on top of the walk-
ing belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
3. Connect the Right Upright Wire Harness (105), the TV
Cable (33), and the Left Upright Wire Harness (131) in
the indicated locations. Push all of the excess wire up
into the Uprights (96, 107). Make sure that all wires are
fully connected. Note: Regardless of which console
your INCLINE TRAINER has, connect all wires so that
the console can later be upgraded if desired.
Refer to step 1. While a second person holds the
Uprights (96, 107), remove the Upright Bolts (106). Slide
the Uprights fully onto the Base Frame (52). Be careful
to avoid pinching your hands or the wires.
2. While a second person holds the Handrail (94) near the
Uprights (96, 107), feed the wires in both sides of the
Handrail down into the Uprights. Pull the ends of the
wires out of the lower ends of the Uprights and remove
the wire ties from the ends of the wires.
Finger tighten four Handrail Bolts (93) into the Handrail
(94) and the Uprights (96, 107) as shown. Be careful to
avoid pinching the wires in the Handrail.
Note: The CD Holder (143) and the Cup Holder (10) are
replaceable. If these parts become dislodged from the
Console (89), simply press them back into place.
94
107
96
93
143
89
10
93
Wires
2
HOW TO SET UP THE INCLINE TRAINER
107
96
105
33
131
3
1. Slide the Right and Left Uprights (96, 107) onto the
brackets near the front of the Base Frame (52). Make
sure that the Uprights are on the correct sides; the
indicated holes must be facing the INCLINE
TRAINER.
Raise the Left Upright (107) until the lower hole in the
front of the Upright is aligned with the upper hole in the
bracket as shown. Thread an Upright Bolt (106) into the
Upright and the bracket. Do not fully tighten the
Upright Bolt yet.
Repeat this step with the Right Upright (96).
107
52
52
Holes
106
106
96
1