Filter
Top Products
34
4. SYMPTOM: THE WALKING BELT IS OFF-CENTER
a. If the walking belt has shifted to the left: Remove the
key and unplug the power cord. Using the included allen
wrench, turn the roller adjustment bolts in the directions
shown, 1/4 of a turn each. Be careful not to overtighten the
walking belt. Plug in the power cord, insert the key and
use the INCLINE TRAINER for a few minutes. Repeat until
the walking belt is centered.
b. If the walking belt has shifted to the right: Remove the
key and unplug the power cord. Using the included allen
wrench, turn the roller adjustment bolts in the directions
shown, 1/4 of a turn each. Be careful not to overtighten the
walking belt. Plug in the power cord, insert the key and
use the INCLINE TRAINER for a few minutes. Repeat until
the walking belt is centered.
c. If the walking belt slips when walked on: Remove the
key and unplug the power cord. Using the included allen
wrench, turn both roller adjustment bolts clockwise 1/4 of a
turn. When the walking belt is properly tightened, you
should be able to lift each side of the walking belt 1 to 2
inches off the walking platform. The center of the walking
belt should just touch the walking platform. Make sure to
keep the walking belt centered. Plug in the power cord, in-
sert the key and run the INCLINE TRAINER for a few min-
utes. Repeat until the walking belt is properly tightened.
5. SYMPTOM: THE WALKING BELT STOPS OR THE INCLINE CANNOT BE ADJUSTED EVEN THOUGH
THE CONSOLE REMAINS LIT
a. This indicates that a controller error may have occurred. To correct the problem, refer to step 8 on page 23.
6. SYMPTOM: THE INCLINE SYSTEM DOES NOT FUNCTION PROPERLY OR THE INCLINE SYSTEM DOES
NOT APPEAR TO BE AT THE INCLINE LEVEL SHOWN IN THE MAIN DISPLAY
a. The incline system may need to be calibrated. To initiate the calibration routine, hold down the SPEED +
button and the SPEED – button simultaneously for three seconds. During the calibration routine, the INCLINE
TRAINER will automatically rise to the highest incline level and then return to the lowest incline level.
b. If the incline system still does not function properly, please call Customer Care toll-free.
7. SYMPTOM: THE WORDS LUBRICATE DECK APPEAR EVERY FEW MINUTES IN THE MAIN DISPLAY
a. If the words LUBRICATE DECK appear in the main display, the walking platform should be checked for ade-
quate lubricant. Follow the instructions in step 4 on page 29 to lubricate the walking platform if necessary.
After you have lubricated the walking platform, refer to HOW TO RESET THE LUBE REMINDER on page 25.
If this is not done, the words LUBRICATE DECK will continue to appear.
a
b
c