Filter
Top Products
NVS 6
MANUAL
Page 21
1 Retainer
2 Tail End
6 Recess
9 Clamp
Assembly of Clamp with Retainer
Figure 6.2
6.1.2 Installation of Counterweight
6.1.2.1 Take counterweight (10) (Ref. Fig. 3.1) from the set of spare
parts, remove the backing of the sticking fastener meant for fastening to
the helmet.
Figure 6.3
6.1.2.2 Bond the removed
fastener to the rear potion of the
helmet external surface so that the
hole made at the center of the
fastener coincides with screw head
(1) (Fig. 6.3), the lower edge of the
fastener therewith should join to the
helmet rubber edging. Before bonding
with adhesive trace the outline of the
fastener on the helmet and
thoroughly remove the paint from the
helmet within the outline.
1 2
9
6
1