Filter
Top Products
16
Note: On a special request a menu of a particular unit can be
simplified to show only required modes.
Setup mode
To modify the Ready to Measure mode parameters:
Enter the Setup mode.
With word Ready on the display press the M button till
display name
COdE is displayed and press the A button.
Select the desired parameter modification (see table below).
Press the M button till the code name of the desired
parameter is displayed and press A button.
To leave the Setup mode without changing measurement
parameters press and hold the M button for two seconds. This
works like the computer Esc key. The rangefinder will then keep
the last set of parameters and return to the Ready to Measure
mode.
Mode
Display name
Distance
Speed
Azimuth
Elevation
Reticle
Target
selection logic
Ready to
Measure
Ready
As set at previous session
Standard1
Std 1
m Deg Deg -¦-
Auto
Standard2
Std 2
m Mils Mils -¦-
Auto