Filter
Top Products
28
MECHANICAL SERVICE GUIDE
9-8 Plug the wires into the new dual board using the
wiring diagram provided in Appendix 1 and 2 .
9-9 Plug the power cord into the wall outlet and start
the treadmill. If the waking belt has a surging
motion you can correct this by slightly turning the
“IR Comp” adjustment pot on the dual board (see
Figure 4 and 4A).
9-10 If the belt speed is too low during calibration
adjust the max “speed” pot to achieve proper
setting. After changing these settings you should
recalibrate (see Figure 4 & 4A).
9-11 Replace the motor cover first, then replace the
lower outer plastic covers using (4) Phillips head
screws per side, and the lower inside upright
plastic cover using (4) Phillips head screws per
side.
Figure 3A:
Figure 4:
Figure 4A:
IR Comp
Speed
Speed
IR Comp
Speed
Speed
IR Comp
IR Comp