Filter
Top Products
18
MECHANICAL SERVICE GUIDE
4-7 Reinstall the elevation potentiometer (see Figure
4) - taking note of the flat spot on the shaft of the
pot in relation to the flat spot on the cam inside the
elevation motor (see Figure 5).
NOTE: Do not force the elevation pot. It should
mate up with little or no pressure.
4-8 Reconnect the elevation cable to the
potentiometer making sure that the colors on the
two wires match up.
4-9 Replace the motor cover first, then replace the
lower outer plastics using (4) Phillips head screws
per side. Replace the lower inside upright plastic
covers using (4) Phillips head screws, per side.
NOTE: Be sure that all wires are secure and out
of the way of any moving parts during
reassembly.
4-10 Recalibrate the treadmill (see Appendix 4).
Figure 4:
Figure 5: