Filter
Top Products
24
MECHANICAL SERVICE GUIDE
7.0 - REPLACEMENT OF UPPER ELECTRONICS
Tools Needed:
• Phillips Screwdriver
NOTE: If using a powered driver, it must be on the
“LOW TORQUE” setting, otherwise it will
strip screws.
7-1 Turn off the power switch and unplug the treadmill
from the wall outlet.
7-2 To access the electronic board remove the (6)
Phillips head screws holding the access panel in
place (see Figure 1).
7-3 Remove all of the jumper wires (see Figure 2 and
2A).
7-4 Remove the (4) small Phillips screws holding
the electronics to the console and remove the
electronics (see Figure 2).
7-5 Reinstall the new electronics making sure the
area between the electronics and the plastic
console is free of any obstructions.
7-6 Plug all wires into their original positions making
sure that each has made a good contact and
replace mounting screws.
7-7 Recalibrate the electronics (see Appendix 4).
7 ! 2 . ) . '
! 4 4 % . 4 ) / .
$ ! . ' % 2
)--%$)!4%!#4)/.2%15)2%$
# ! 5 4 ) / .
AS LONG AS THE TREADMILL IS PLUGGED INTO A
POWERED OUTLET AND THE TREADMILL CIRCUIT
BREAKER IS ON, THE UNIT IS RECEIVING POWER,
EVEN IF THE DISPLAY IS TURNED OFF. ALWAYS
UNPLUG THE POWER CORD FROM THE OUTLET
AND TREADMILL WHEN PERFORMING REPAIRS OR
MAINTENANCE.
Figure 1:
Figure 2:
Figure 2A: