Filter
Top Products
18
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2
STEP 17:
5
• SECURELY assemble the swivel end of the CABLE to the BACK PIVOT (5) using one 3/8 X 1-3/4” BOLT (13), two RH CAPS
(28), two 3/8” RH WASHERS (23) and one 3/8” LOW HEIGHT LOCK NUT (21). (NOTE: SECURELY tighten, then back
nut off 1/4 turn) (NOTE: If CABLE is too short, loosen bolts on HANDLES and slide HANDLES up. Securely tighten.)
• REFER TO SHROUD KIT ASSEMBLY INSTRUCTIONS.
3/8 X 1-3/4” 13
5
21
23
28
CABLE
FIGURE 17
CABLE
DIAGRAM
SEE NOTE
1A