Filter
Top Products
STEP 13:
• Insert the two GUIDE RODS (35) (found in SHROUD KIT box) into the base of the TOWER (1) as shown in FIGURE 13. Lubricate
the GUIDE RODS (35) with a slicon or teflon spray that is available at most hardware stores.
• Slide two WEIGHT STACK CUSHIONS (27) down over the GUIDE RODS (35). See FIGURE 13.
• Using EXTREME CARE slide twenty 10 LB. WEIGHT PLATES (36) over the GUIDE RODS (35) as shown in FIGURE 13.(NOTE:
If HEAVY WEIGHT OPTION is being used, slide ten 15LB. WEIGHT PLATES (37) and ten 10 LB. WEIGHT PLATES
(36) over the GUIDE RODS (35)
• Carefully Slide the HEAD PLATE (12) down over the GUIDE RODS (35) onto the weight stack as shown in FIGURE 13.
• Slide one WEIGHT STACK SELECTOR PIN (26) over the shaft on the HEAD PLATE (12) as shown in FIGURE 13.
FIGURE 10
14
• Slide two GUIDE ROD BUSHINGS (31) over each GUIDE ROD (35).
• Slide two 1” SHAFT COLLARS (29) over each GUIDE ROD (35) as shown in FIGURE 13.
• Place the GUIDE ROD SUPPORT (4) over the GUIDE RODS (35) as shown in FIGURE 13.
27
36
35
12
26
29
31
4
1
36
HEAVY WEIGHT OPTION
37
1A