11
STEP 8:
FIGURE 8
• SECURELY assemble the HANDLES (3) to the BACK PIVOT (5) using four RH CAPS (28), two 3/8 X 2-3/4” BOLTS (15),
four 3/8” SAE WASHERS (22), four 3/8” RH WASHERS (23) and two 3/8” LOW HEIGHT LOCK NUTS (21) as shown in
FIGURE 8. (NOTE: Before tightening bolts, push HANDLES (3) down until the bolts are at the top of the slots in
plate.)
• Assemble one RUBBER BUMPER (30) to the BASE FRAME (2) where the HANDLES (3) contacts the BASE FRAME (2).
2
30
3/8 X 2-3/4” 15
28
3
5
22
21
23