• SECURELY assemble the BACK PIVOT (5) to the REAR FRAME (6) using four previously inserted 3/8 X 3” BUTTON HEAD
CAP SCREWS (17), four RH WASHERS (23), four 3/8” SAE WASHERS (22), four 3/8” LOW HEIGHT LOCK NUTS (21) and
four RH CAPS (28) as shown in FIGURE 7.
STEP 7:
FIGURE 7
TIGHTEN!
SET SCREWS
• IMPORTANT! When BACK PIVOT (5) is centered and level in the PILLOW BLOCKS (25), tighten the PILLOW BLOCK set
screws.
17 3/8 X 3” BUTTON HEAD
6
28
22
23
21
10
25
5
1A