Filter
Top Products
16
STEP 15:
FIGURE 15
• Route the LAT CABLE (AM) around one 3-1/2” PULLEY (35) and assemble the PULLEY to the LEFT (D) and RIGHT (E)
BOOM PLATES using one 3/8 X 3-3/4” BOLT (6), two 3/8 X 15/16” SPACERS (24) and one 3/8” LOCK NUT (19). See FIG-
URE 15. (NOTE: Make sure the cable runs in the grooves of the pulleys.)
• Route the LAT CABLE (AM) through the PRESS ARM SUPPORT FRAME (X) and assemble one 3-1/2” PULLEY (35) to the
FRAME PRESS ARM SUPPORT FRAME (X) using one 3/8 X 8” BOLT (3), two 3/8” WASHERS (18), two 3/8 X 1-1/4” SPAC-
ERS (25) and one 3/8” LOCK NUT (19). See FIGURE 15.