Filter
Top Products
FIGURE 17
STEP 17:
¯ Loosen the two 1/2 X 3" BOLTS (34) holding the UPPER CROSS SUPORT (11) to the TOWER (1) as shown in FIGURE
FIGURE
18
STEP 18:
* Assemble FRONT SI-IP, OUD (16) over thepro-
truding bolts, then assemble the REAR
SHROUD (17) inside c~fthe FRONT SHROUD
(16). (NOTE: Make ~re shrouds are under-
neath the washers.) S~:e FIGURE 18.