Filter
Top Products
19
FIGURE 17
STEP 17:
• Screw the treaded end of the CABLE (21) approximately 3/4” into the end of the WEIGHT STACK SHAFT (17) and tighten jam nut
securely. See FIGURE 17.
• If the HEAD PLATE (18) does not sit on top of the first WEIGHT PLATE (16), push the head plate down, insert the SELECTOR PIN
(49) and perform several repetitions on the machine. This will relax the cable system and prevent the HEAD PLATE (18) from lifting
up.
• If after completing the previous step the HEAD PLATE (18) still does not sit on top of the first WEIGHT PLATE (16) or if there is
excess slack in the cable system, adjust the threaded end of the CABLE accordingly and retighten the jam nut.
• Route the threaded end of the CABLE (21) through the holes and around the pulleys in the TOWER BRACE (7) as shown in FIGURE
17.
21
18
49
16
17
1
7