FIGURE 10
13
• Insert the two GUIDE RODS (20) into the base of the TOWER (1) as shown in FIGURE 10. Lubricate the GUIDE RODS with a
slicon or teflon spray that is available at most hardware stores.
• Slide two WEIGHT STACK CUSHIONS (23) down over the GUIDE RODS (20). See FIGURE 10.
• Using EXTREME CARE slide twenty WEIGHT PLATES (16) down over the GUIDE RODS (20) with the key-hole facing as
shown in FIGURE 10.
• SECURELY assemble the WEIGHT STACK SHAFT (17) to the HEAD PLATE (18) using one 3/8 X 1-1/4” BOLT (39) and
one 3/8” WASHER (42). (Note: The bolt hole in the HEAD PLATE (18) should be on top.)
• Carefully Slide the HEAD PLATE ASSEMBLY down over the GUIDE RODS (20) onto the weight stack as shown.
STEP 10:
• Apply one set of WEIGHT STACK LABELS - LBS. OR #1-25 (54) (55) to each WEIGHT PLATE (16). See FIGURE 10.
23
39
3/8 X 1-1/4”
20
18
42
17
16
54
1
55
• Slide two 13/16” SHAFT COLLARS (28) over the GUIDE RODS (20) as shown in FIGURE 10.
28