Filter
Top Products
FIGURE 7
10
• Slide two PILLOW BLOCKS (27) over the shaft on the PRESS ARM ADJUST (5) and SECURELY assemble the two PILLOW
BLOCKS (27) to the UPPER SUPPORT (8) using four 3/8 X 3-1/4” BOLTS (35), four 3/8” WASHERS (42), and four 3/8” LOCK
NUTS (45) as shown in FIGURE 7.
STEP 7:
0
1
2
3 4 5
6
1/2 1/2 1/2 1/2 1/2 1/2
• Center PRESS ARM ADJUST (5) on top of the STOP POST on the PRESS BASE (2) and securely tighten set screws on the
PILLOW BLOCKS (27). See FIGURE 7.
2
51
42
• Insert two 1/2” FLANGE BEARINGS (51) into the bushings on the PRESS ARM ADJUST (5). See FIGURE 7.
45
27
5
8
STOP
POST
SHAFT
3/8 X 3-1/4” 35