Filter
Top Products
14
•Fit a hex bushing, keyed side down, into the center hole
in of each rear wheel.
17
•Position the rear wheel with the driver side down.
• Before applying labels to the rear wheels, wipe each
wheel with a clean, dry cloth to make sure it is free of
dirt and oils. Make sure your hands are clean.
• Apply label #16 to each rear wheel, as shown.
16
Hex Bushing
Rear Wheel
Hex Bushing
Keyed Side
•Position a rear wheel with indented side up.
•Position the driver so that the ribbed side is up.
•Fit the driver into the rear wheel, as shown.
• Insert a #10 x
1
/
2
" screw through one of the the holes in
the driver and into the rear wheel. Tighten the screw with
a Phillips screwdriver. Do not over-tighten.
• Repeat this procedure to assemble the other driver into
the other rear wheel.
15
Driver
(Ribbed Side Up)
Rear Wheel
(Indented Side Up)
Label #16
Assembly
•Pull a rear fender out slightly to fit a rear wheel onto the
end of the drive axle.
Note: Make sure the teeth in the rear wheel driver fit into
the motor gearbox.
18
Rear Wheel
(with Hex Bushing)
Driver Teeth
Motor
Gearbox
Drive
Axle
Pull
Rear
Fender
Out
Right Side View