Filter
Top Products
9
Console Instructions
Console Layout and Design
Take a few moments to review the console layout.
Below is an overview of the console and their different functions.
A. Powering Up:
Connect adapter into power source1.
If the connection cables were installed incorrectly, monitor will display “E1” on matrix 2.
display and will generate a long beeping sound. Before asking service, please examine if all
connection cables are well connected and then reset the power to release the beep sound
or press START / STOP (Hold to reset) button to restart system. If the monitor still show
“E1” message, please call service.
If the monitor shows “ E2 ”message, please call service.3.
(b) Start/Stop
(a) Pulse Recovery
(c) Enter
(d) Increase
(e) Decrease
To change from miles to kilometers and
vice versa, ip the switch highlighted inside
the circle. Once switched, you must restart
the console to activate.
The miles / kilometer switch is located on the
back of the console. To remove the console,
push in the tab of the lower part
of the console and lift up.