Filter
Top Products
FITNESS SYSTEMS
RR
H T
O
I
S
2601 Assembly
Page - 47
O W N E R S
M A N U A L
HOIST FITNESS SYSTEMS
GENERAL MAINTENANCE INFORMATION
Links, Pull-Pins, Snap Locks, Swivels, Weight Stack Pins:
F Check all pieces for signs of visible wear or damage.
F Check springs in snap hooks and pull-pins for proper tension and alignment.
F If the spring sticks or has lost its rigidity, replace it immediately.
Upholstery:
F To ensure prolonged upholstery life and proper hygiene, all upholstered pads should be wiped down with a damp
cloth after every workout.
F Periodically take the time to use a mild soap or an approved vinyl upholstery cleaner to deter the onset of cracking or
drying. Avoid using any abrasive cleaners or cleaners not intended for use on vinyl.
F Replace ripped or worn upholstery immediately.
F Keep sharp or pointed objects clear of all upholstery.
Guide Rods:
F Wipe clean with a clean, dust free rag.
F If lubrication is required, lube with Waylube Oil ONLY or damage to the Top Weight Bearing may occur.
F DO NOT repeatedly clean the shafting with alcohol or any other stripping cleanser! The Top Weight Bearing
transfers a gliding material to the guide rods. Cleaning other than wiping with a clean, dust free rag will remove the
previously transferred material and increase the wear to the Bearing Liner.
Decals:
F Inspect and familiarize yourself with any safety warnings or other user information posted on each decal.
Nuts and Bolts:
F Inspect all nuts and bolts for any loosening and tighten if needed.
F Go through a re-tightening sequence periodically to ensure that all hardware is tensioned properly.
Belts and Cables:
F Hoist uses only high quality belts, and mil-spec cables.
F Visually inspect the belts and cables for fraying, cracking, peeling or discoloration.
F While the machine is not in use, carefully run your fingers along the belt or cable to feel for thinning or bulging
areas.
F Replace belts and cables immediately at the first signs of damage or wear. Do not use equipment until belts or cables
has been replaced.