Filter
Top Products
A S S E M B LY
I N S T R U C T I O N S
F R A M E A S S E M B L Y
Step 2e
FITNESS SYSTEMS
RR
O
H I
S
T
1 - Weight Cage
14 - Add on Rods
15 - Weight Selector Pin
16 - Guide Rod
17 - Guide Rod Bushing
18 - Weight Bumpers
19 - 20 LB Intermediate Weight
20 - 15 LB Aluminum Top Plate
21 - Center LH BRK (Add on)
22 - 5 LB Add on Weight
31 - Bushing for Cast Add on Weight
Part Descriptions
E - 5/16”-18 x 1” Button Head
F - 3/8”-16 x 1” Button Head
G - 3/8”-16 x 1” Button Head (White Zinc)
H - 3/8”-16 x 2 3/4” Button Head (White Zinc)
AA - 1/2” Lock Washer
AK - 3/8” Flat Washer
CT - Selector Pin Lanyard
CV - Guide Bearing (Tall)
AE - 3/8” Flat Washer
AF - 3/8” Lock Washer
AG - 5/16” Flat Washer
AH - 5/16” Lock Washer
AJ - 3/8” Lock Washer
CW - Guide Bearing (Short)
Hardware Descriptions
2601 Assembly
Page 15
In this step start by pressing
Wrench tighten
bolts including all previously hand tightened bolts.
(17) in (1), then place (18) over (17)
and insure holes are lined up. Next slide in two (16)’s in (1). Slide fifteen
(19)’s and one (20) onto both (16)’s. Make sure the weight stack and its
guide rods are sitting level and bolt the tops of (16) to (1). Attach (14) to
(21) and secure (21) to (20),then press two (31)’s in each of the three
(22)’s and slide on three (22)’s on to (21). Next attach (14) to (1). Attach
the bigger end of (CT) to (21) and the other end to (15).