Filter
Top Products
23
H
OW TO OPERATE THE PERSONAL TELEVISION
IMPORTANT: Before operating the television, you
must connect a 75 ohm CATV cable to the 75 ohm
terminal on the treadmill. See page 10 for instruc-
t
ions.
Follow the steps below to operate the television.
Insert the key into the console.
See HOW TO TURN ON THE POWER on page
14.
Press the On/Off button to turn on the
television.
When the key is inserted, the television will auto-
matically turn on. If you have turned off the televi-
sion, turn it on by pressing the On/Off button.
Press the Channel buttons to select the
desired cable channel.
Note: Complete this step only if you are using
analog cable. Otherwise, change channels
through an external source such as your cable
box or your VCR.
When the television is turned on, the screen will
show the last cable channel that was selected. To
s
elect a different channel, press the Channel but-
tons. The selected cable channel number will ap-
p
ear on the screen for a few seconds. Note: The
television is equipped with a channel memorizing
function that allows you to go directly from the cur-
rent channel to the next channel saved in mem-
ory. Before channels can be selected in this way,
they must be saved in the television’s memory.
See HOW TO USE THE INFORMATION MODE
on page 24.
Press the Volume buttons to adjust the volume.
When either Volume button is pressed, the vol-
ume level indicator will appear on the screen for a
few seconds.
To use earphones or headphones (not included),
plug them into the headphone jack on the console.
When you are finished using the television,
press the On/Off button.
Press the On/Off button to turn off the television.
Note: Removing the key from the console will also
turn off the television.
5
4
3
2
1