Filter
Top Products
8
4. Hold the Left Upright (88) against the Base
(91). Be careful not to pinch the Upright
Wire (77) or the Ground Wire (90). Insert two
3/8" x 2 3/4" Patch Screws (7) and two 3/8" x
1 1/4" Patch Screws (8) with two 3/8" Star
Washers (13) into the Left Upright.
Partially tighten the 3/8" x 2 3/4" Patch Screws
(7) and the 3/8" x 1 1/4" Patch Screws (8) until
the heads of the Patch Screws touch the Left
Upright (88); do not fully tighten the Patch
Screws yet. Note: It may be helpful to use the
Short Hex Key (110) on the Bolt shown.
Attach the Right Upright (not shown) in the
same way. Note: There are no wires on the
right side.
88
91
4
8
8
7
13
77, 90
13
3. Identify the Left Upright (88), which is marked
with a “Left” sticker. Have a second person hold
the Left Upright near the Base (91).
See the inset drawing. Tie the wire tie in the
L
eft Upright (88) securely around the Upright
Wire (77) about 8 in. (20 cm) down from the
end. Then, pull the other end of the wire tie until
the Upright Wire is routed completely through
the Left Upright. Note: The Upright Wire should
bend so that the connectors are pointing down-
ward.
77
3
77
88
Wire
Tie
88
91
77
110
W
ire Tie