Filter
Top Products
7
ASSEMBLY
1. Make sure that the power cord is unplugged.
Place a piece of cardboard under the rear of the
Frame (57) to protect the floor or carpet.
Attach the Left Wheel Cap (92) to the Base (91)
with two #8 x 3/4" Screws (2).
Attach the Right Wheel Cap (not shown) to
the Base (91) in the same way.
1
92
91
2
57
Cardboard
2. Pull the Upright Wire (77) and the Ground Wire
(90) through the indicated hole in the Base (91).
Attach the Ground Wire (90) to the Base (91)
with a #8 x 1/2" Ground Screw (10).
77
2
Hole
10
90
91
• To hire a service technician to assemble this
product in your home, call 1-800-445-2480.
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the pack-
ing materials until you finish assembly.
• The underside of the walking belt is coated with
high-performance lubricant. After shipping, there
may be some lubricant on top of the walking belt
or on the shipping carton. This is normal. If there
is lubricant on top of the walking belt, wipe it
off with a soft cloth and a mild, non-abrasive
cleaner.
• To identify small parts, see page 6.
•
Assembly requires the following tools:
the included hex key
one adjustable wrench
one Phillips screwdriver
scissors
needlenose pliers
To avoid damaging parts, do not use power
tools for assembly.