Filter
Top Products
21
6. Measure your heart rate if desired.
Note: If you use the handgrip pulse sensor and
t
he chest pulse sensor at the same time, the
console will not display your heart rate accu-
r
ately. For information about the chest pulse sen-
sor, see page 16.
Before using
the handgrip
pulse sensor,
remove the
sheets of plas-
tic from the
metal contacts
on the pulse
bar. In addi-
tion, make
sure that your
hands are clean.
To measure your heart rate, stand on the foot
rails and hold the pulse bar with your palms on the
metal contacts; avoid moving your hands. When
your pulse is detected, your heart rate will be
shown. For the most accurate heart rate read-
ing, continue to hold the contacts for about 15
seconds.
7. Turn on the fan if desired.
The fan features several speed settings. Press the
F
an increase or decrease button to select a fan
speed or to turn off the fan. Note: If the fan is on
w
hen the walking belt is stopped, the fan will turn
off automatically after a few minutes.
8. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to zero per-
cent. The incline must be at zero percent or you
may damage the treadmill when you fold it to
the storage position. Next, remove the key from
the console and put it in a secure place.
When you are finished using the treadmill, press
the power switch into the off position and unplug
the power cord. IMPORTANT: If you do not do
this, the treadmillʼs electrical components may
wear prematurely.
Contacts