Filter
Top Products
10
8. Set the console assembly on the brackets on
the Left and Right Uprights (88, not shown). Be
careful not to pinch any wires.
Attach the console assembly with four 5/16" x
1 1/4" Patch Screws (4) and four 5/16" Star
Washers (11) (only one side is shown). Start all
four Patch Screws, but do not tighten them
until assembly step 12 is completed.
Insert the excess Upright Wire (77) into the hole
in the console assembly. Tighten the ties around
the Upright Wire and cut off the ends of the ties.
8
Console
Assembly
11
4
88
77
Bracket
Ties
7. With the help of a second person, hold the con-
sole assembly near the Left Upright (88).
R
oute the Upright Wire (77) around the indicated
crossbar. Then, route the Upright Wire through
t
he looped ties on the bottom of the console as-
sembly.
Connect the Upright Wire (77) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF YOU DO NOT CONNECT THE CON-
NECTORS PROPERLY, THE CONSOLE MAY
BECOME DAMAGED WHEN YOU TURN ON
THE POWER.
Console
A
ssembly
88
7
77
77
Console
Wire
C
onsole
Wire
Ties
C
rossbar