Filter
Top Products
AssembJyrequirestwopersons.Setthetreadmillinacbaredareaandremoveallpackingmaterials,Donot
disposeof the packingmatedaJsuntil assemMyis completed.
Note:Theundersideofthetreadmillwalkingbeltiscoatedwithhigh@erformancelubricant,Duringshipping,a
smallamountoflubricantmaybetransferredtothetopofthewalkingbeltortheshippingcarton,Thisisa normal
conditionanddoesnotaffecttreadmillperformance,if thereislubricantontopofthewalkingbelt,simplywipeoff
thelubricantwithasoftclothanda mild,non-abrasivecleaner,
E
Assembly requires the included hex key _ and your own phillips screwdriver
Use the drawings below to identify the hardware used during assembly, Note: if a part is not in the parts bag,
check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic
parts, do not use power tooJs for assemMy.
3/4" Screw (23)-6
0
3/8" Star
Washer (83)-4
1" Tek Screw (77)-4
©
Pulse Bar Star
Washer (65)-4
Endcap Screw
(79)-2
1 1/4" Tek Screw (108)-2
Silver Pulse Bar
Screw (64)-4
< 38
Cover Screw (52)-4
Console Screw (67)-4
2 3/4" Upright Bolt (85)-2
1" Upright Bolt (84)-2
1 1/4" Bolt (63)-4
1, Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side as shown, Partially
fold the Frame (26) so that the treadmill is more
stable, Do not fully fold the Frame until the
treadmill is completely assemMed.
identify the Right Upright (76) which has a
RIGHT sticker, Hold the Right Upright near the
Base (81), insert the Upright Wire (75) into the
Right Upright until the Upright Wire is extending
from the upper end of the Right Upright, Note:
Make sure that the Upright Wire is extending
from the side of the post as shown in the inset
drawing, Remove the tie from the Upright Wire,
Thread a 2 3/4" Upright Bolt (85) and a 1" Upright
Bolt (84) with 3/8" Star Washers (83) into the
Base (81) and the bottom of the Right Upright
(76), Do not tighten the Upright Bolts yet,
76
26
83