Filter
Top Products
TROUBLESHOOTmNG
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and
follow the steps listed, mfyou need further assistance, please see the front cover of this manual.
PROBLEM: The power does not turn on
SOLUTmON: a,
Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor
is plugged into a properly grounded outlet (see page 12). Use only a single-outlet surge suppres-
sor that meets all of the specifications described on page 12. important: The treadmill is not com-
patible with GFCl-squipped outlets.
b. After the power cord has been plugged in, make sure that the key is inserted into the consols.
C, Check the reset/off circuit breaker located on the
treadmill frame near the power cord. if the switch
protrudes as shown, the circuit breaker has
tripped. To reset the circuit breaker, wait for five
minutes, and then press the switch back in.
Tripped
PROBLEM: The power turns off during use
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above), if the circuit breaker has tripped, wait
for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. if the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key into the console.
d. if the treadmill still will not run, see the front cover of this manual.
PROBLEM: The incline of the treadmill does not change correctly
SOLUTmON: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re-
move the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the
maximum incline level and then return to the minimum level. This will recalibrate the incline system.
PROBLEM: The disptay of the console does not function property
SOLUTmON: a, Remove the key from the console and UNPLUG THE
POWER CORD. With the help of a second person,
carefully tip the Uprights (70, 76) down as shown,
Remove the three Hood Screws (11) and two 3/4"
Screws (23), Note: A phillips screwdriver with a shaft
at bast 5" long is required.
11
23
22